|
|
| Check out Intravia's Guide |
| |
Home of Knight Business Systems
INTRAVIA’S SERVICE GUIDE TO SHARP "Z"COPIERS
$35.00
| |
|
|
We now have a manual devoted to these machines. It covers the following models:
Sharp Z20, Z23, Z25, Z27, Z30, Z50, Z52, Z52II, Z55, Z57, Z57II, Z60, Z70, Z72, Z75, Z76,
Z77, Z85, Z85II, Z85III, Z87, Z88, SF2010, SF6000. Xerox 5008, 5008RE, 5008S, 5009, 5201,
5203, 5205, 5206, 5210, 5220, 5222, 5240, 5260, 5280, 5305, 5307, 5308, 5309, 5310, Lanier
6610. This book includes theory, operation, disassembly procedures, troubleshooting methods,
recommendations, shortcuts, part numbers. I am able to brag that this book has information
that is not included in the factory manuals, including trouble codes that the manufacturer
omitted! 95 pages $35.00
Z book Sample Page
Z85 & Z88 (5309 & 5310) Paper Feed Tire Replacement Procedure.
This is the same procedure that is necessary to access the paper feed clutch.
Remove stack feed assembly ( 2 screws and one connector).
Remove toner cartridge & drum cartridge.
Remove cassette.
Remove power supply cover (bottom rear).
Note position of feed tires. Reassemble so that flat section is parallel to paper.
Done with holes in hub.
Remove E-ring near paper feed clutch. If removing only tire sleeves, remove E-rings from other
end and slide new rubber tires on without further disassembly.
Remove inner hub & collar from shaft.
Remove gear from shaft.
Remove E-ring on paper shaft (inside clutch). Remove bushing from shaft.
Stand machine on exit end.
Remove E-ring & washer on front side of paper feed shaft (under machine).
Remove paper feed tire shaft assembly from machine.
Reverse process to reassemble.
Real Easy Feed Problem: A small plastic gear is merely pushed onto its shaft. It sometimes
falls off or walks off far enough not to engage. Just put it back.
Cassette: On occasion, you may want to disassemble the cassette and stretch the spring that
pushes the paper up. You can also replace the spring if you wish.
Exposure Lamp Stays On Constantly: Usual cause of this is the power supply board.
Z52 / 57 Scan Clutch: To minimize future problems, I recommend replacing the scan rail when
replacing the clutch.
Click Here to Order Now!
Main Page
Service Guides
Training
Jim's Corner
Order Form
This page designed, maintained and hosted by
Advanced Design
